Actual HPE6-A45 Exam Recently Updated Questions with Free Demo [Q16-Q35] – IT Certification Exam Questions & Answers

Rate this post

Actual HPE6-A45 Exam Recently Updated Questions with Free Demo

Free HP HPE6-A45 Exam Questions Self-Assess Preparation

For more info read reference:

Course Training

How to book HPE6-A45 Implementing Aruba Campus Switching solutions Exams

The registration for the HPE6-A45 Implementing Aruba Campus Switching solutions Exam follows the steps given below:

Step 1: Visit the website Pearson VUE
Step 2: Navigate to Certifications.
Step 3: Search for the exam name HPE6-A45 Implementing Aruba Campus Switching solutions
Step 4: Book the exam.

QUESTION 16
Which switches can be deployed in a mesh topology for backplane stacking?

Aruba 2920 switches

Aruba 2930F switches

Aruba 2930M switches

Aruba 3810 switches

QUESTION 17
Refer to the exhibit.

A network administrator sets up prioritization for an application that runs between Device 1 and Device 2. However, the QoS for the application is not what the administrator expects.
How can the administrator check if the network infrastructure prioritizes traffic from Device 1 and Device 2?

Run a packet capture on Device 2, run the application, and look in the packet capture for a high value DSCP in the IP header.

Set up RMON alarms on the switches that trigger when a high number of packets are dropped. Then, run the application and check for the alarm.

Clear interface statistics on the switches. Then, run the application and check the interface queue statistics for the switch-to-switch links.

Run a packet capture on Device 1, run the application, and look in the packet capture for a high value DSCP in the IP header.

QUESTION 18
A network administrator can set the OSPF metric type on an AOS-Switch to Type 1 or Type
2. What is the
difference?

A Type 2 metric marks external routes that can be advertised in NSSAs, while a Type 1 metric marks external routes that can only be advertised in normal areas.

A Type 2 metric assigns cost to a 100 Gbps link, while a Type 1 metric assigns cost 1 to all links of 100 Mbps or higher.

A Type 2 metric is assigned to multiple external routes that are aggregated together, while a Type 1 metric does not permit external route aggregation.

A Type 2 metric stays the same as the external route is advertised, while a Type 1 metric increments with internal OSPF link costs.

QUESTION 19
Refer to the exhibits.
Exhibit 1

Exhibit 2

In the exhibits, VLAN 20 under a device name indicates that the device is configured with that VLAN. The exhibits also indicate whether VLAN 20 is statically configured on each link, either as an untagged or a tagged VLAN. If the link has no label, VLAN 20 is not statically configured on that link.
A network administrator needs to deploy AOS-Switches that use port-based tunneled node. The plan calls for tunneled-node endpoints to be assigned to VLAN 20 and for the Aruba Mobility Controller to handle the tunneled-node traffic at Layer 2. Which exhibit shows the correct plan for VLAN 20 in the wired infrastructure?

QUESTION 20
What must an OSPF router do to ensure nonstop routing should a standby member take over as commander when the original VSF commander fails?

It must run the shortest path first algorithm

It must participate in a new election for the Designated Router

It must initiate a graceful restart

It must re-establish adjacency with its Designated Router.

QUESTION 21
An AOS-Switch needs to be configured to support tunneled node in role-based mode. The Mobility Controller administrators tell the switch administrators that the AOS-Switch will integrate with a cluster of Mobility Controllers. The Cluster virtual IP address is 10.1.1.10.
How should switch administrators integrate the AOS-Switch with the cluster?

Double-check the settings with the Mobility Controller administrators because the planned configuration is incompatible with the switch settings.

Configure the virtual IP address as the tunneled-node-server address: tunneled node will not, but the clustering features will not provide redundancy.

Configure the virtual IP address as the tunneled-node-server address: The switch will automatically learn controller IP addresses to which to tunnel various traffic.

Configure the virtual IP address for the primary tunneled-node-server and an actual controller IP address for the backup tunneled-node-server in order to receive redundancy.

QUESTION 22
What is a primary use case for RPVST+ on AOS-Switches?

more granular load balancing than MSTP when access switches connect to two core switches

enhanced loop protection in an MSTP network

integration of AOS-Switches in a heterogeneous vendor network that uses the Cisco protocol

seamless integration with RSTP

QUESTION 23
A customer wants access layer switches that support routing, ACLs, backplane stacking, and Smart rate ports. The customer asks about Aruba 5400R z 12 switches.
Which Aruba Switch model would better meet the customer’s requirements?

2530

2930F

3810

8400

QUESTION 24
Refer to the exhibits.
Exhibit 1

Exhibit 2

Exhibit 1 shows a portion of the BGP routing table when the BGP solution was first deployed. Exhibit 2 shows the same portion at the current time. What can explain the current state?

Due to changes in the private network, Switch-1 can no longer reach 192.168.2.1.

Switch-1 can no longer reach ISP 1 at 192.168.1.1.

Due to changes at ISP 1, Switch-1 now selects a different best route.

An administrator has applied a route map on Switch-1 that filters advertised routes.

QUESTION 25
Exhibit

The exhibits show the current operational state for routes on Switch-3. The company wants Switch-3 to prefer the link to Switch-1 over the link to Switch-2 for all intra-area, inter-area, and external traffic. What can the network administrator do to achieve this goal?

Set the OSPF cost on VLAN 108 higher than 1 on Switch-2 and Switch-3.

Set the OSPF administrative distance on Switch-2 higher than 110.

Set the OSPF area type to normal on all of the switches in Area 1.

Set the cost in the OSPF Area 1 stub command higher than 1 on Switch-2.

QUESTION 26
Refer to the exhibit.

The routing switches shown in the exhibit run OSPF on the links between each other. The commander in the Switch-1 VSF fabric goes down. Traffic is disrupted for several seconds.
What should a network administrator do to support a faster failover in a similar situation?

Configure echo mode BFD on the VLAN that connects Switch-1 and Switch-2.

Add VRRP on the VLAN between Switch-1 and Switch-2.

Configure graceful restart, or nonstop OSPF, on Switch-1 and Switch-2, with a proper timer.

Create a redundant virtual link between Switch-1 and Switch-2.

QUESTION 27
Refer to the exhibit.

AOS-Switches will enforce 802.1X authentication on edge ports. The company has two RADIUS servers, which are meant to provide redundancy and load sharing of requests. The exhibit shows the planned RADIUS settings to deploy to the switches.
What should customers understand about this plan?

AOS switches do not support two RADIUS servers for redundancy, instead, a secondary authentication method is required.

Dynamic authentication is only permitted on one of the RADIUS servers and must be removed from the other.

Each RADIUS server must use a unique port number for the authentication and dynamic authorization port.

Each AOS-Switch will send all RADIUS requests to the first server on the list unless that server becomes unreachable.

QUESTION 28
Exhibit

The network administrator enables DHCP snooping globally and on VLAN 2.
An additional step is mandatory for DHCP snooping to operate correctly and for clients to receive HDCP settings.
What is the additional mandatory step?

Define trk1 as a trusted DHCP port.

Define an authorizes DHCP server.

Enable ARP protection.

Define edge ports as untrusted DHCP ports.

QUESTION 29
A company has AOS-switches, Aruba ClearPass, and Aruba AirWave. A network administrator needs to find the source of a performance issue that often occurs at the start of the day and early in the afternoon.
Which action is likely to give the administrator the most useful information for the investigation?

Access the Network Device view on ClearPass.

Use the configuration audit tool on AirWave.

View the current running config on each switch.

View usage patterns on the switches on AirWave.

QUESTION 30
Refer to the exhibit.

A network administrator needs to alter myACL so that it permits all traffic that arrives in VLAN 2 and is destined to 10.1.10.0/24. Besides this change, the ACL must continue to act as it does now. The administrator plans this new rule:
permit ip any 10.1.10.0/24
How should the administrator apply this rule to meet all requirements?

Apply the new rule without a rule ID to ensure that the switch applies the automatic processing order to it.

Resequence the ACL with more space, then add the new rule with a sequence ID before the ID for the current third rule.

Remove the ACL from the VLAN and re-apply it as an inbound VLAN ACL (VACL). Then, add the new rule with any ID higher than 2.

Enable ACL grouping on the switch. Add the new rule in a new ACL. Then, group the new ACL with myACL.

QUESTION 31
Refer to the exhibit.

A company wants to change Area 1 shown in the exhibit from a stub area to a totally stub area.
What will be one effect of this planned change?

Routing devices within Area 0 will temporarily lose adjacency with each other.

Switch-1 and Switch-2 will adjust the cost with which they advertise area 1 traffic in the backbone.

Some traffic from Area 1 to other areas will no longer follow the lowest cost path.

Endpoints within Area 1 will no longer be able to reach endpoints in other areas.

QUESTION 32
Refer to the exhibit.

Network administrators set up PIM-DM to route multicast traffic from Server 1 to clients in VLAN 24. The multicasts are not active now, but the administrators want to determine which path the multicasts will take.
What should the administrators check to help them calculate this path?

If Switch-2 or Switch-3 has the highest IP address on a VLAN that runs PIM-DM.

If Switch-2 or Switch-3 is listed as an RP in the Switch-1 RP set

What the next hop is for the unicast route that Switch-1 uses to reach 10.2.2.2

If the Switch-2 DR priority on VLAN 10 is higher than the Switch-3 DR priority on VLAN 11

QUESTION 33
A network administrator wants to use an ACL, acl1, to control traffic from devices in VLAN
12 as the traffic is routed out of VLAN 12. The ACL should not control traffic within the VLAN.
Which keyword should the administrator enter at the administrator enter at the end of this command:
Switch(config)# vlan 12 ip access-group acl1____

out

vlan-in

vlan-out

QUESTION 34
Refer to the exhibit.

A network administrator wants to add the protections of root guard to the network. Based on the spanning tree topology, on which ports should the network administrator implement root guard?

3-24

1 and 2

A1 and A2

2 and A3

QUESTION 35
OSPF Area 1 has two ABRs. One ABR is configured with this range for Area 1: 10.10.0.0/16. The other ABR is configured with this range for Area 1: 10.10.0.0/17.
Which type of issue occurs due to this mismatch?

The ABRs lose adjacency entirely and cannot route traffic between each other at all.

The ABRs create a discontiguous area and disrupt intra-area routing between devices within Area 1.

The ABRs advertise routes inconsistently, and they could potentially introduce a routing loop.

The ABRs lose adjacency in Area 1 and must route all traffic to each other through Area 0.

What is the duration, language, and format of HPE6-A45 Implementing Aruba Campus Switching solutions Exam

Length of Examination: 125 minutes
Format: Multiple choices, multiple answers, short answer questions.
Language: Czech, simplified Chinese, traditional Chinese, Dutch, English (UK), English (US), French, German, Indonesian, Italian, Japanese, Korean, Polish, Portuguese, Portuguese (Brazil), Russian, Slovak, Spanish, Spanish (Latin America), Thai, Turkish, and Vietnamese
Passing score: 73.5%
Number of Questions: 40-45 multiple-choice and short-answer questions.

HPE6-A45 Free Sample Questions to Practice One Year Update: https://www.it-tests.com/HPE6-A45.html