[May-2026 Newly Released] Pass 201 Exam – Real Questions & Answers [Q23-Q38] – IT Certification Exam Questions & Answers

Rate this post

[May-2026 Newly Released] Pass 201 Exam – Real Questions and Answers

Pass 201 Review Guide, Reliable 201 Test Engine

NO.23 A BIG-IP Administrator is conducting maintenance on one BIG-IP appliance in an HA Pair. Why should the BIG-IP Administrator put the appliance into FORCED_OFFLINE state?

To preserve existing connections to Virtual Servers and reduce the CPU load

To allow new connections to Virtual Servers and ensure the appliance becomes active

To terminate connections to the management IP and decrease persistent connections

To terminate existing connections to Virtual Servers and prevent the appliance from becoming active

NO.24 A pool of four servers has been partially upgraded for two new servers with more memory and CPU capacity. The BIG-IP Administrator must change the load balance method to consider more connections for the two new servers. Which load balancing method considers pool member CPU and memory load?

Round Robin

Dynamic Ratio

Ratio

Least Connection

NO.25 A BIG-IP device has only LTM and ASM modules provisioned. Both have nominal provisioning level. The BI6-IP Administrator wants to dedicate more resources to the LTM module. The ASM module must remain enabled. Which tmsh command should the BIG-IP Administrator execute to obtain the desired result?

modify/sys provision asm level minimum

modify /sys provision Itm level dedicated

modify /sys provision asm level none

modify /sys provision Itm level minimum

NO.26 Which action will take place when a failover trigger is detected by the active system.

The active device will take the action specified for the failure.

The standby device also detects the failure and assumes the active role.

The active device will wait for all connections to terminate and then failElover.

The standby device will begin processing virtual servers that have failed, but the active device will continue servicing the functional virtual servers.

NO.27 A BIG-IP Administrator need to ensure that a pool member and down by the monitor the BIG-IP system sends existing connections to another be pool member.
Which should the BIG-IP Administrator perform to meet this goal?

Set Action on Service Down sing under the server configuration to reselect.

Reconfigure the pool motor members as UP.

Enable mirroring within the persistence profile.

Set Action Service Down setting under the pool configuration to reselect.

NO.28 A set of servers is used for an FTP application as well as an HTTP website via separate BIG-IP Pools. The server support team reports that some servers are receiving a lot more traffic than others.
Which Load Balancing Method should the BIG-IP Administrator apply to even out the connection count?

Ratio (Member)

Least Connections (Member)

Least Connections (Node)

Ratio (Node)

Explanation
The connection is required to be balanced, and the unit is the server and the application port is the unit, so it is node.

NO.29 A BIG-IP Administrator receives an RMA replacement for a failed F5 device. The BIG-IP Administrator tries to restore a UCS taken from the previous device, but the restore fails. The following error appears inthe/var/log/itm.
mcpd [****J: ******>;0; License is not operational (expired or digital signature does not match contents.) What should the BIG-IP Administrator do to avoid this error?

Use the appropriate tmsh command with the no-license option

Revoke the license prior to restoring

Reactivate the license on the new device using the manual activation method

Remove the license information from the UCS archive

NO.30 A site is load balancing to a pool of web servers. Which
statement
is true concerning BIGElIP’s ability to verify whether the web servers are functioning properly or not.

Web server monitors can test the content of any page on the server.

Web server monitors always verify the contents of the index.html page.

Web server monitors can test whether the server’s address is reachable, but cannot test a page’s content.

Web server monitors can test the content of static web pages, but cannot test pages that would require the web server to dynamically build content.

NO.31 When configuring a Virtual Server to use an iRule with an HTTP_REQUEST event, which lists required steps in a proper order to create all necessary objects?

create profiles, create the iRule, create required pools, create the Virtual Server

create the Virtual Server, create required pools, create the iRule, edit the Virtual Server

create a custom HTTP profile, create required pools, create the Virtual Server, create the iRule

create required pools, create a custom HTTP profile, create the iRule, create the Virtual Server

NO.32 A user wants to use the iHealth Upgrade Advisor to determine any issues with upgrading TMOS from 13.0 to 13.1.
Where can the user generate the QKView to upload to iHealth?

System > Software Management

System > Archives

System > Configuration

System > Support

NO.33 Which two statements are true concerning the default communication between a redundant pair of BIGElIP systems. (Choose two.)

Synchronization occurs via a TCP connection using ports 683 and 684.

Connection mirroring data is shared via a TCP connection using port 1028.

Persistence mirroring data is shared via a TCP connection using port 1028.

Connection mirroring data is shared through the serial faiEl lover cable unless network failElover is enabled.

NO.34 Which two statements are true about NATs. (Choose two.)

NATs support UDP, TCP, and ICMP traffic.

NATs can be configured with mirroring enabled or disabled.

NATs provide a oneEltoElone mapping between IP addresses.

NATs provide a manyEltoElone mapping between IP addresses.

NO.35 A BIG-IP Administrator makes a configuration change to a Virtual Server on the Standby device of an HA pair. The HA pair is currently configured with Auto-Sync Enabled. What effect will the change have on the HA pair configuration?

The change will be undone when Auto-Sync propagates the config to the HA pair.

The change will be propagated next time a configuration change is made on the Active device.

The change will be undone next time a configuration change is made on the Active device.

The change will take effect when Auto-Sync propagates the config to the HA pair.

NO.36 A BIG-IP Administrator runs the initial configuration wizard and learns that the NTP servers were invalid. In which area of the Configuration Utility should the BIG-IP Administrator update the list of configured NTP servers?

System > Configuration

System > Services

System > Preferences

System > Platform

NO.37 Refer to the exhibit.

How are new connections load balanced?