Get Nov-2024 Dumps to Pass your D-PDD-DY-23 Exam with 100% Real Questions and Answers [Q57-Q76] – IT Certification Exam Questions & Answers

Rate this post

Get Nov-2024 Dumps to Pass your D-PDD-DY-23 Exam with 100% Real Questions and Answers

Updated Exam D-PDD-DY-23 Dumps with New Questions

NEW QUESTION 57
What is the correct sequence of operations used by the PowerProtect DD DIA in the end-to-end verification process?

NEW QUESTION 58
A backup administrator is tasked with verifying the compression savings of a PowerProtect DD9900.
Which compression algorithm will they see enabled by default?

lzw

gzfast

NEW QUESTION 59
An organization uses tape libraries in their current backup infrastructure. They have purchased a PowerProtect DD system and plan to use VTL to move from physical tape.
What is a consideration when configuring the tape size?

Use multiple drives to write multiple streams

Set retention periods for as long as possible

Target multiple drives to write single stream

Use larger tapes for multiple smaller datasets

NEW QUESTION 60
A backup administrator has enabled the Retention Lock feature on their PowerProtect DD appliance.
Over time, the administrator noticed an increase in file system utilization.
Upon further investigation, the administrator discovered expired files are still present on the appliance.
What is the most likely reason for this issue?

The time of the file was set below the minimum retention period

Retention Lock feature was disabled before the expiration date

File system cleaning was disabled

Backup application failed to delete the file after expiration

NEW QUESTION 61
What is a requirement to use the PowerProtect DD HA feature?

Each head unit requires its own FS25 shelf

Head units and nodes require an active/active configuration

A single set of shared storage

Dual set of shared storage configuration

NEW QUESTION 62
A PowerProtect DD system is configured to with VTL. The backup application requires a minimum tape capacity of 1.5 TiB.
What is the minimum tape type to support this requirement?

LTO-5

LTO-6

LTO-3

LTO-4

NEW QUESTION 63
What is the maximum number of snapshots per MTree that can be stored on a PowerProtect DD

100

128

NEW QUESTION 64
If PowerProtect DD administrator issue a cifs share destroy command, what is the result?

The CIFS share and contents of the share are deleted.

The contents of the CIFS share are deleted.

The CIFS share is deleted.

NEW QUESTION 65
What does the system setup wizard require to set up a VTL on a PowerProtect DD system?

DHCP

Gateway IP

HBA

WWPNs

NEW QUESTION 66
A customer has stored the data that is in the cloud using PowerProtect DD. For security reasons, encryption will be applied to the data.
What is the required action to achieve the customer’s goal?

Encrypt and reupload the data

Enable the encryption via cloud tier level

Activate the Data at Rest encryption

Turn off encryption and reenable

NEW QUESTION 67
What is the preferred method to ensure backups are protected against deletion or corrupt?

Encryption

Dell EMC Cloud Tier

Retention Lock

Data Invulnerability Architecture

NEW QUESTION 68
A technician is upgrading a DD9400 with a DS60 expansion shelf with 60 drives. In the GUI interface, only 30 drives are accessible.
What is causing these drives to be inaccessible?

There are not enough cache drives on the DD9400 to support the extra capacity.

A second SAS connection from DD9400 to DS60 is not activated.

There are not enough spare drives.

The capacity license applied is only for 30 drives.

NEW QUESTION 69
What are the terminal emulation settings that are used to establish serial communication with a PowerProtect DD system?

BAUD Rate: 116200
Data Bits: 8
Stop Bits: 1
Parity: Even
Flow Control: Xon/XOFF

BAUD Rate: 115200
Data Bits: 8
Stop Bits: 1
Parity: None
Flow Control: None

BAUD Rate: 115200
Data Bits: 1
Stop Bits: 2
Parity: None
Flow Control: None

BAUD Rate: 116200
Data Bits: 1
Stop Bits: 2
Parity: Odd
Flow Control: Xon/XOFF

NEW QUESTION 70
An administrator notices that several disks on a shelf show as unknown.
What should be done to resolve this issue?

Enter the disk unfail command for the unknown disks

Enter the storage add enclosure command

Ensure the expansion shelf is cabled properly

Cycle the power on the newly added expansion shelf

NEW QUESTION 71
Which command is used to start the initial CLI configuration wizard?

config setup

install config

config

setup

NEW QUESTION 72
Which protocols are supported by PowerProtect DD appliances for data movement to the Cloud Tier?

CIFS, NFS, and DD Boost

VTL, CIFS, and NFS

DD Boost and CIFS only

NFS and CIFS only

NEW QUESTION 73
What is a key differentiator of Dell PowerProtect DD systems in terms of data handling during the write process?

Data is deduplicated after it is written to disk.

Data is encrypted after it is written to disk.

Data is stored in its original format without any optimization.

Data is deduplicated and encrypted inline as it is written to disk.

NEW QUESTION 74
Which two applications use the client direct feature? (Select 2)

Veritas Backup Exec

Avamar

Dell NetWorker

IBM Spectrum Protect

NEW QUESTION 75
An engineer is deploying a new PowerProtect DD9900 system that includes ES40, DS60, and FS25 expansion shelves.
What should the engineer consider when cabling the hardware?

The FS25 shelf should be cabled on a separate chain

The DS60 shelf should be cabled on a separate chain

The FS25 shelf must be fully populated

The DS60 shelf must be populated with identical drives

NEW QUESTION 76
A customer needs a backup system to protect 100 TB of mission-critical data.
What should be used to back up the system?

cloud tier

DD6900

DD3300

DDVE

Loading …